Table of Contents
Advertisement
2. Cut the 20mm square tube with
a hacksaw. Make the cut so that
the line is left on the discarded
part of the tube.
3. Now mark and cut the 4mm
spindle so that it is 40mm longer
than the tube.
4. With the Coupler Bush aligned to the rear of the vehicle insert the Tube and Coupler Bush
through the ceiling hole and into the antenna unit. Aluminium Tube should not protrude
past the coupler bush.
REAR OF VEHICLE
12
CRANK UP NZ INSTRUCTIONS MASTER.indd 12
40mm
17/09/2013 13:01
Advertisement
Table of Contents
