Ambient Light - Vivotek CaMate Series User Manual

LED indicator
LED indicator activates or deactivates the information status LED, i.e. red and green LEDs (not the IR
illumination LEDs). Because of opaque front cover in the IR models, I8 and I9, the LED indicators only
can be seen in the non‐IR CaMate products, i.e. w5. Below are the definitions of LED indicators:

Red LED constant ON means normal operation, OFF means system is not working.

Red LED flashes every 1 second means IR LEDs are overheated, flashes every 3 seconds
means LED voltage is out of range.

Green LED flashes means the device received and executing commands.

If both red and green LEDs flash simultaneously, the device upgrading its firmware.

Ambient Light

Ambient Light reports the current ambient lighting level. The ambient light level is polled every 10
seconds. The light sensor detection control may have a max. of 10 seconds delay when the ambient
light level changes.
LED Light Level
LED Light Level controls the strength of LED lighting from 100% (default setting, max. power
consumption) to 20% when the LED is ON.
DO Mode
The DO mode defines the function of DO pin. The DO signal can be used to report three conditions:
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
12