Replacing Support Bearings, Replacing Crankshaft Rear Seal - Volvo DH10A 245 Service Manual

1819
2665
1801
8010
6088
78
2000
Replacing support bearings
Special tools:
(999) 1801 Standard handle
1819 Extractor
2665 Press tool
1. Remove the support bearing using extractor 1819.
2. Tap in the new support bearing into position in the
flyhweel.
Replacing crankshaft rear seal
(Clutch removed)
Special tools:
(999) 2000 Handle
6088 Drift
8010 Extractor
1. Remove the flywheel.
2. Tap out the seal using extractor 8010.
3. Clean the seal seat in the flyhweel casing.
4. Apply gasket sealant (part no. 1161277) to the seal
outer circumference and fit the seal.
5. Fit the flywheel. Tighten the flyhweel, or flange
+5
disc bolts, to 185
–10
+0.5
Nm (18.5 kpm).
–1.0