Volvo DH10A 245 Service Manual page 141

Radiator, removing/installing
Special tool:
(999) 9954 Component lift
1. Close the taps for the bus heating system.
Drain the coolant.
2. Take off the drive belts and remove the fan.
3. Remove...
– the hoses for the coolant and intercooler
– the engine rear plate on the inside of the air cleaner
– both the edge plates in front of the radiator assem-
bly.
4 Place lift 9954 under the radiator assembly.
5. Remove...
– the upper retaining iron bars
– the outer lower bracket with rubber pads
– the inner lower bracket without rubber pads.
6. Lower as far as possible the radiator assembly with
the lift.
Raise the bus and pull out the radiator assembly.
Installing
1. Place the radiator assembly on lift 9954.
Raise the bus enough to run the radiator assembly
in underneath.
2. Lower the bus and raise the lift far enough so that
the assembly mount brackets can be bolted on.
Fit and tighten all the bracket bolts and lower the
lift.
3. Connect up the hoses for the intercooler and cool-
ant.
Install the fan and fit the drive belts.
Adjust the drive belts.
140
4. Fill with coolant and open the taps in the bus heat-
ing system.
Start the engine and check for leakage.
Top-up with coolant if necessary.
5. Fit the edge plates and the engine rear plate.