Important Safety Instructions; Safety Instructions For Multi-Purpose Tool - Haussmann Xpert DMT109 Operator's Manual

IMPORTANT SAFETY INSTRUCTIONS

11. Avoid accidental starting.Be sure switch is off before plugging in. Carrying
tools with your finger on the switch or plugging in tools with the switch on invites
accidents.
12. Remove adjusting keys before turning the tool on. A wrench or a key that is
left attached to a rotating part of the tool may result in personal injury.
13. Do not overreach.Keep proper footing and balance at all times. Proper
footing and balance enables better control of the tool in unexpected situations.
14. Use safety equipment. Always wear eye protection. Dust mask, non-skid
safety shoes, hard hat, or hearing protection must be used for appropriate conditions.
TOOL USE AND CARE
15. Use clamps or other practical way to secure and support the work piece to a
stable platform. Holding the work by hand or against your body is unstable
andmay lead to loss of control.
16. Do not force tool.Use the correct tool for your application. The correct tool
will do the job better and safer at the rate for which it is designed.
17. Do not use tool if switch does not turn it on or off. Any tool that cannot be
controlled with the switch is dangerous and must be repaired.
18. Disconnect the plug from the power source before making any adjustments,
changing accessories, or storing the tool. Such preventive safety measures
reduce the risk of starting the tool accidentally.
19. Store idle tools out of reach of children and other untrained persons. Tools
are dangerous in the hands of untrained users.
20. Maintain tools with care. Keep cutting tools sharp and clean. Properly
maintained tools with sharp cutting edge are less likely to bind and are easier to
control. Do not use a damaged tool.Tag damaged tools"Do not use" until
repaired.
21. Check for misalignment or binding of moving parts, breakage of parts,and
any other condition that may affect the tool's operation. If damaged,have
the tool serviced before using. Many accidents are caused by poorly
maintained tools.
22. Use only accessories that are recommended by the manufacturer for your
model. Accessories that may be suitable for one tool may become hazardous
when used on another tool.
SERVICE
23. Tool service must be performed only by qualified repair personnel. Service
or maintenance performed by unqualified personnel could result in a risk of injury.
24. When servicing a tool, use only identical replacement parts. Follow
instructions in the Maintenance section of this manual. Use of unauthorized
parts or failure to follow Maintenance instructions may create a risk of electric
shock or injury.

SAFETY INSTRUCTIONS FOR MULTI-PURPOSE TOOL


Hold power tools by insulated gripping surfaces when performing an
operation where the cutting tools may contact hidden wiring. Contact with a
"live" wire will make exposed metal parts of the tool "live"and shock the
operator.Do not drill, fasten or break into existing walls or other blind areas where
electrical wiring may exist. If this situation is unavoidable, disconnect all fuses or
circuit breakers feeding this worksite.

Use a metal detector to determine if there are gas or water pipes hidden in
the work area or call local utility company for assistance before beginning
the operation. Striking or cutting into a gas line will result in explosion.Water
entering an electrical device may cause electrocution.
16
DMT109