Maintenance - Haussmann Xpert DMT109 Operator's Manual

OPERATION
CUTTING
The sawing teeth are very sharp. Do not touch during mounting and application.
Before sawing make sure that no live cables will be damaged. The workpiece
must be inserted firmly or clamped tightly before it is processed.
Only clamp the plunge cut saw blade and saw in a straight position. For fixation use a
tightening screw with a large disc.Carefully remove the protective coating.
Always set the plunge cut saw blade straight (at 90°) and guide it in the gap without
tilting. Always guide the plunge cut saw blade along the cutting line without exerting
any pressure.
When plunging and sawing with a slight pendulum motion,make sure that sufficient
chip removal is provided for.
Keep a certain distance away from hard metals (stone/metal) (approx. 0.118" 3mm),
since there is increased danger of the outer saw teeth breaking off.
SCRAPING
For scraping, use a high speed only. Work on a soft surface (e.g.wood) at a flat angle,
and apply only light pressure. Otherwise the scraper can cut into the surface.

MAINTENANCE

DOUBLE INSULATION
Double insulation is a concept in safety in electric power tools, which eliminates the
need for the standard 3-wire ground power cord. All exposed metal parts are isolated
fromthe internal motor components with protecting insulation.Double insulated power
tools do not need to be grounded.
EXTENSION CORDS
The use of any extension cord will cause some loss of power.To keep the loss at a
minimum and to prevent overheating, use an extension cord that is heavy enough to
carry the current that the tool will draw.
ENVIRONMENTAL PROTECTION
End of life electrical equipment must not be placed in household waste. Please take it
to a tool recycling centre. Find out about your nearest recycling centre from your
council or sales outlet.
MAINTENANCE & REPAIRS
WARNING: Service, testing and repairs may only be carried out by service
technicians in conformity with the regulations valid in Canada.
We recommend our customer service department (repair centre).
Please hand these operating instructions to the repair centre. An overview of spare
parts can be found at the end of these operating instructions.
Only use original supplier spare parts.
CLEANING
For regular clenaning: Carry out the following steps once a week, or more often if
used frequently:
Clean the cooling air vents.
Use non-metallic tools to clean the air vents.
22
DMT109
!