Haussmann Xpert DMT109 Operator's Manual page 19

ASSEMBLY
Selecting the Application Tool/Accessory
A c e c s s o y r
Carbide
rasp(triangular)
Carbide-tipped saw
blade
Segment saw
blade
Plunge cut saw
blade, (1-1/4"/30mm)
Plunge cut saw
blade, (3/4"/20mm)
Plunge cut saw
blade, (3/8"/10mm)
Rigidscraper blade
Flexible Scraper
blade
Base plate for sand-
ing, series Delta
Sanding finger
M a e t i r l a A p p c i l
Tile adhesive, For coarse sanding, filler, tile adhesive,
concrete, stone concrete, stone and wood. Suitable for use
without or with the dust extraction
Plaster, porous For cutting out defective tile joints and for
concrete and similar milling cracks in plaster, porous concrete
building materials and similar building materials. Recessed,
flush cut capable
Wooden materials, Separating and plunge cuts; also for sawing
plastic, close to edges, in corners and hard to reach
non-ferrous metals areas;
Example: shortening already installed bottom
rails or door hinges, plunge cuts for adjusting
panels
Wooden materials, Separating and deep plunge cuts; also for
plastic, gypsum and sawing close to edges, in corners and hard to
other soft materials reach areas;
Example: Sawing
ings
Wooden materials, Middle separating and plunge cuts;
plastic, gypsum and Example: Cut-outs in furniture for cable
other soft materials connections
Wooden materials, Smaller separating and plunge cuts;
plastic, gypsum and Example: Cut-outs in furniture for cable
other soft materials connections
For removing tough old lacquers,
Carpets, coverings
remainders of adhesives, carpeting, tile
adhesives and under seal coatings
Silicone or acrylic For removing silicone or acrylic caulking
caulking
Depends on sanding Sanding surfaces close to edges, in corners or
sheet hard to reach areas;
Depending on the sanding sheet for, e.g.,
sanding wood, paint, varnish, stone, glass
Depends on sanding For use in extremely tight and hidden spots,
sheet channels,grooves,openings and folds
t a o i n
water pipes (PVC) or
19