Important Safety Instructions For Air-Powered Ratchet Wrench - Haussmann Xpert PNT108 Operator's Manual

GENERAL SAFETY INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS FOR AIR-POWERED RATCHET WRENCH

Use only the lubricants supplied with the tool and specified by the manufacturer.

AIR SUPPLY AND CONNECTIONS
The air supply connection must not hold pressure when air supply is disconnected.

If an incorrect fitting is used, the tool can remain charged with air after
disconnecting and thus will be able to work even after the air line is disconnected,
possibly causing injury.
Do not use any type of reactive gases, including, but not limited to, oxygen and

combustible gases, as a power source. Use filtered, lubricated, regulated
compressed air only. Use of a reactive gas instead of compressed air may cause
the tool to explode which will cause death or serious personal injury.
Use only a pressure-regulated compressed air source to limit the air pressure

supplied to the tool. The regulated pressure must not exceed 100 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 200 PSI. The
tool could explode which will cause death or serious personal injury.
Always disconnect air resource:

a. Before making adjustments.
b. When servicing the tool.
c. When clearing a jam.
d. When tool is not in use.
e. When moving to a different work area, as accidental actuation may occur,
causing injury.
1. Inspect the air-powered heavy duty ratchet wrench prior to each use in order to:
a) ensure that the proper power source is being used;
b) verify that the tool is in proper working order.
2. Do not use a tool that is not in proper working order.
3. Do not use oxygen or any other combustible or bottled gas to power this tool.
4. Do not use this tool in the presence of flammable liquids or gases.
5. Only use sockets that are specifically designed for use with this air-powered heavy
duty ratchet wrench.
6. Verify that the air valve (or trigger) on the air-powered heavy duty ratchet wrench
is in the "off" position before connecting the air-powered heavy duty ratchet
wrench to the air supply.
7. This wrench requires an air pressure of 90 PSI and air flow according to the
specifications that appear at the beginning of this Manual.
8. Drain the air tank daily. Water in the air line will damage the air-powered ratchet
wrench.
9. Clean the air inlet filter weekly.
10. The pressure in the line should be increased in order to compensate for an
unusually long air hose (longer than 26' [8 m]). The diameter of the hose should
be 3/8" (10 mm) ID.
11. Keep the hose away from heat, oil, and sharp edges. Check the hose for wear,
and verify that all connections are secure.
12. Do not use the air-powered heavy duty ratchet wrench for a task that it is not
designed to perform.
13. Do not use air-powered heavy duty ratchet wrench if it is damaged or if there is
reason to believe that it is defective.
14. Do not use air-powered heavy duty ratchet wrench without having been instructed
in its use by a qualified person.
15. Do not carry the air-powered heavy duty ratchet wrench by the air hose.
15