Troubleshooting - Scheppach Tiger7000s Original Instruction Manual

Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment. By properly dis-
posing of this product, you are also contributing to the
effective use of natural resources. You can obtain in-
formation on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.

14. Troubleshooting

Problem Possible cause
Engine does not run. Engine, cable or connector
defective, fuses burnt.
The engine starts slowly Voltage too low, coils damaged,
and does not reach the capacitor burnt.
operating speed.
Engine producing Coils damaged, motor defective.
excessive noise.
Engine does not reach Circuits in the network are
full power. overloaded (lamps, other engines,
etc.)
Motor overheats easily. Overloading of the engine,
insufficient cooling of the engine.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Remedy
Have the machine checked by a specialist. Never
repair the engine yourself. Attention! Check the fuses
and replace them if necessary.
Have the power supply company check the voltage.
Have the engine checked by a specialist. Have the
capacitor replaced by a specialist.
Have the engine checked by a specialist.
Do not use any other devices or engines on the same
circuit.
Avoid overloading the engine during grinding and
remove dust from the engine to ensure optimum
engine cooling.
GB | 25