Subscribe to Our Youtube Channel
Related Manuals for KoolMore CIM-350
Summary of Contents for KoolMore CIM-350
- Page 1 Commercial Undercounter Ice Maker User Manual for Installation and Maintenance Model: CIM-350...
-
Page 2: Table Of Contents
Table of Contents Important Information Warning and safety instruction General Installation Location for Installation Schematic Diagram of Installation Installation Steps Startup and Operation Operation Instruction Instruction of Control Panel Maintenance Service Call Common Faults and Troubleshooting Warranty Note: please keep this manual in a place accessible to users at any time.. -
Page 3: Important Information
Important Information Please pay attention to the following warning The label indicates a flammable foaming agent labels on the ice maker “Cyclopentane” used. There is a risk of fire. The label indicates a flammable refrigerant “R290” used. There is a risk of fire. The label indicates a hazardous voltage. - Page 4 Instruction of symbols in this Manual Warning sign, special attention is required. Warning sign, special attention is required, and operation is prohibited.
-
Page 5: Warning And Safety Instruction
Warning and safety instruction ✦ The ice machine must be placed on the This product cannot be used in outdoor floor sufficient to supports its weight. environment. Insufficient base cause This ice machine is not intended for use equipment fall over and cause injury. by children, and those with physical ✦... -
Page 6: General
SERVICE PERSONNEL. EXPLOSION. DISPOSE OF PROPERLY PUNCTURE REFRIGERANT TUBING. IN ACCORDANCE WITH FEDERAL OR LOCAL REGULATIONS. FLAMMABLE • CAUTION – RISK FIRE REFRIGERANT USED. EXPLOSION. FLAMMABLE REFRIGERANT USED. CONSULT • CAUTION – RISK FIRE REPAIR MANUAL/OWNER'S GUIDE EXPLOSION DUE TO PUNCTURE OF BEFORE ATTEMPTING TO SERVICE REFRIGERANT TUBING;... -
Page 7: Schematic Diagram Of Installation
Modular Ice Maker User Manual for Installation and Maintenance Schematic Diagram of Installation... -
Page 8: Installation Steps
Modular Ice Maker User Manual for Installation and Maintenance Installation Steps 1. Check if the ice machine is in good body. condition accessories Note: This machine is equipped with an complete; check the machine model and inlet water filter. The filter will keep the machine nameplate. -
Page 9: Operation Instruction
automatically. machine; ✔ The ice machine has no abnormal noise; 3. For normal operation, please confirm: ✔ There is water in the water trough and no ✔ The ice machine has no abnormal overflow occurs; vibration; ✔ The pump is working properly and water is ✔... -
Page 10: Instruction Of Control Panel
Modular Ice Maker User Manual for Installation and Maintenance Instruction of Control Panel 1. LED Display: enter the cleaning process. During the entire cleaning process, cleaning agents • Self-check： Display “ini” code. and disinfectants need to be put into the water trough. -
Page 11: Maintenance
The fault code and its comments are displayed as follows: Code Error Machine status Water Curtain failure or Ice Full Sleeping mode will recover after Switch the water curtain is reset Ice Harvest Overtime Protective shutdown High Temperature Protective shutdown Protective shutdown and retry Water Shortage Fault every 30 mins... -
Page 12: Service Call
Water pipe In order to ensure food safety, the water pipe of the ice machine should be cleaned regularly. Wintering Turn off the water and power supply, drain the residual water from the water trough, inlet pipe and drain pipe. Note: Be careful when doing the The maintenance of the ice machine is condenser cleaning as the edges of the fins... - Page 13 ✔ Check the nameplate located on the side user’s faults, such as no supply of water, or back of the ice machine and record the electricity or environmental factors, rather model and series number of the ice than the fault of the ice maker, the door-to- machine.
- Page 14 Troubleshooting Issue Potential cause Troubleshooting Not working Power switch not turned on Turn on the power switch Indicator is “OFF” Plug is loose Check plug and socket The display shows E04 high The ambient temperature is too high Normal working temperature 41-95°F temperature Clean the condenser and air filter.
- Page 15 • Equipment that has been altered, modified, or repaired by anyone other than an authorized service agency outside of preventative maintenance and cleaning. • Parts deemed by Koolmore to be normal wear and tear parts, including hoses and select plastic or rubber Components. For Warranty Inquiries or Service:...
- Page 16 This warranty is only valid on equipment purchased from an authorized dealer. Locate the model number on the rating label Next, call 1-718-576-6342. You must have the model number when contacting service technicians.
Need help?
Do you have a question about the CIM-350 and is the answer not in the manual?
Questions and answers