Edge; Fig 24 Rf Control Values - Nokia NPL-4 Series Troubleshooting Instructions

Nokia Customer Care
The setup should now look like this:
Now the measurement equipment should detect the following output signal of the
phone:
P = +23dBm @ 1747.8 MHz
out
If this is not the case, then go to the chapter GMSK for the troubleshooting.

EDGE

Select operation mode to the "local".
Select->Testing -> RF control
In the popup window common values:
Active unit:->TX
Band:->1800
Operation mode: ->Burst
RX/TX Channel:->700
In the popup window TX control values:
EDGE:->ON
Copyright © 2005 Nokia Corporation. All rights reserved.
Issue 2 05/05
Company confidential
-TX Data Type->Random
Figure 24: RF Control Values
NPL-4/5/
Troubleshooting Instructions
Page 39