Troubleshooting - Beem Power Station Pro4 Operating Instructions Manual

EN
The following table will help you locate and eliminate minor faults:
fault
Power indicator (8)
does not light up or
the iron does not heat
up
Stains in ironed wa-
shing
Water tank light does
not light up
Water leaks out of the
ironing sole
Washing remains
creased
Singed areas on the
ironed washing
Power indicator
(8) flashes quickly,
temperature displays
switched off, buttons
do not function
BEEM - Elements of Lifestyle

Troubleshooting

Possible cause
Plug not inserted into
mains socket
No mains power
Iron not switched on.
Defective lamp
Water in tank is discolou-
red
Temperature setting is too
low
Calcium filter not installed
Water tank not locked in
Temperature setting is too
low
Required temperature not
yet reached
Temperature too low
Temperature too high
Problem with appliance
circuitry, appliance is in
safety mode
Power Station Pro4
Remedy
Insert plug
Check the mains socket or auto-
matic circuit breaker
Set iron to desired temperature (4)
Contact customer service
Always empty the water tank
after use
Increase temperature, see
section "Selecting the ironing
temperature"
Install calcium filter
Water tank not properly inserted
Increase temperature, see
section "Selecting the ironing
temperature"
Wait for a few seconds
Set temperature as high as pos-
sible. Pay attention to the label
in the garment!
Set temperature lower and allow
iron to cool down Pay attention
to the label in the garment!
Disconnect appliance from
mains, wait a few seconds and
reinsert the plug. If the problem
is not solved, notify customer
service
25