Table of Contents
Advertisement
I N S T A L L A T I O N
Cut out the work surface according to the sizes shown in the drawing. For the purpose of
installation and use, a minimum of 50mm space must be left around the hole. Be sure the
thickness of the work surface is at least 30mm. Please select heat-resistant work surface material
to avoid deformation caused by the heat radiation from the hob. See below:
L (mm)
W (mm)
H (mm)
590
520
55
W A R N I N G :
Always ensure the hob is well ventilated and the air inlet and outlet are not blocked. Ensure the
ceramic hob is in good working order. See below:
A (mm)
B (mm)
C (mm)
760
50 (min)
20 (min)
NOTE:
For safety, the distance between the hob and the cupboard above should be at least 760mm.
20
Instruction manual C816C
Please keep this instruction manual for future reference
D (mm)
A (mm)
B (mm)
51
564
494
50 (min)
D
E
Air intake
Air exit (5mm)
B E F O R E I N S T A L L I N G T H E H O B
› The ceramic hob must be installed by qualified personnel or technicians. Please never conduct
the installation by yourself.
› Check the work surface is square and level, and no structural parts interfere with the space
requirements.
› Ensure the work surface is made of a heat-resistant material.
› If the hob is installed above an oven, check the oven has a built-in cooling fan.
› The installation must comply with all clearance requirements and applicable standards and
regulations.
› Ensure a suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and positioned to comply with the local wiring
X (mm)
rules and regulations.
› The isolating switch must be of an approved type and provide a 3mm air gap contact
separation in all poles (or in all active [phase] conductors if the local wiring rules allow for this
variation of the requirements).
› The isolating switch must be easily accessible to the customer once the hob is installed.
› Consult local building authorities and by-laws if in doubt regarding installation.
› Use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces.
A F T E R I N S TA L L I N G T H E H O B
› Ensure the power supply cable is not accessible through cupboard doors or drawers.
› Ensure there is an adequate flow of fresh air from outside the cabinetry to the base of the hob.
› If the hob is installed above a drawer or cupboard space, a thermal protection barrier is
installed below the base of the hob.
› The isolating switch must be easily accessible by the customer.
B E F O R E L O C AT I N G T H E F I X I N G B R A C K E T S
› The unit should be placed on a stable, smooth surface (use the packaging).
Do not apply force onto any controls protruding from the hob.
Instruction manual C816C
Please keep this instruction manual for future reference
21
Advertisement
Table of Contents
