Table of Contents
Advertisement
SE 2223/3223 Scan Engine Integration Guide
Programmable Raster Height And Raster Expansion Speed
Parameter # E4h, E5h
This parameter selects the laser pattern's height and rate of expansion, and is only used
when Programmable Raster or Always Raster is enabled. This parameter is intended for
very specific applications, and is usually not necessary.
Select the laser pattern's height and/or rate of expansion.
1. Scan the bar code for either Raster Height or Raster Expansion Speed below.
2. Scan two numeric bar codes beginning on
value. Valid values are between 01 and 15.
3. If you make an error, or wish to change your selection, scan Cancel.
9-18
Raster Height (Default 15)
Raster Expansion Speed (Default 11)
page 9-134
that represent a two-digit
Advertisement
Table of Contents
