Table of Contents
Advertisement
8 electrolux
• When you wash the pan supports by
hand, take care when you dry them as
the enamelling process occasionally
leaves rough edges. If necessary, remove
stubborn stains using a paste cleaner.
• Make sure you position the pan supports
correctly after cleaning.
• To make the burners work correctly,
make sure that the arms of the pan sup-
ports are in the centre of the burner.
• Be very careful when you replace the
pan supports to prevent the hob top
from damage.
After cleaning, dry the appliance with a soft
cloth.
Removing the dirt:
1. – Remove immediately: melting plas-
tic, plastic foil, and food containing
sugar.
– Stop the appliance and let it cool
down before you clean: limescale
rings, water rings, fat stains, shiny
metallic discolorations. Use a special
cleaner applicable for surface of hob.
2. Clean the appliance with a damp cloth
and some detergent.
3. At the end rub the appliance dry
with a clean cloth.
Warning! Do not use knives, scrapers
or similar instruments to clean the
surface of the glass or between the
rims of the burners and the frame (if
applicable).
Warning! Do not slide cookware over
the glass because it could scratch the
surface. Also, do not let hard or sharp
objects fall onto the glass or hit the
edge of the hob.
CLEANING THE ELECTRIC HOTPLATE
Clean the appliance after each use.
Always use cookware with clean bottom.
Warning! Before any maintenance or
cleaning can be carried out, you must
disconnect the hob from the electricity
supply.
The hob is best cleaned while it is still
warm, as spillage can be removed
more easily than if it is left to cool.
Scratches or dark stains have no effect
on how the appliance operates.
Removing the dirt:
1. Use the fine scouring powder or a
scouring pad to remove the dirt.
2. Clean the appliance with a damp cloth
and some detergent.
3. Heat the hotplate to a low temperature
and leave to dry.
4. To maintain the hotplates, wipe the
plates with a drop of olive oil on a kitch-
en towel to prevent rust.
Important! For stainless steel edges of the
hob use cleaner for stainless steel.
The stainless steel edge of the plate
can be slightly discoloured as a result
of the thermal load.
CLEANING OF THE SPARK PLUG
This feature is obtained through a ceramic
ignition candle with a metal electrode. Keep
these components well clean to prevent dif-
ficult lighting and check that the burner
crown holes are not obstructed.
PERIODIC MAINTENANCE
Periodically speak your local Service Force
Centre to check the conditions of the gas
supply pipe and the pressure adjuster, if fit-
ted.
Advertisement
Table of Contents
