BRP SEA-DOO ADVANCED TEC 2010 User Manual page 27

smo2010-004-401_a
1. Locking devices
5. Remove taillight from trailer by
pulling it upwards.
smo2010-004-402_a
6. Carry out same steps for removing
the other taillight.
7. Make sure the way is clear behind
the trailer (in and out of water).
8. Attach ropes to the watercraft
mooring cleats and prevent them
from hanging.
9. Have someone guiding you and
back the vehicle until trailer reaches
the desired depth into water.
NOTE: The PWC must not float above
the bunks.
10. Hold the winch handle firmly and
set winch mechanism to "unwind".
https://www.boat-manuals.com/
smo2010-003-012_a
SET WINCH TO "UNWIND"
11. Unwind until watercraft slides off
the trailer and floats. It may be
necessary to push the watercraft a
little.
12. Grab the ropes previously attached
to the mooring cleats, then moor
the watercraft.
13. Drive the tow vehicle out of the
ramp.
14. Install taillights on trailer.
15. Connect taillights connector.
_______________
LAUNCHING THE WATERCRAFT
25