What To Do If - Zanussi ZTH485 User Manual

* if necessary (approx. once every 6 months)
remove the fluff from the heat exchanger using
the sponge supplied (put on rubber gloves)
Cleaning the drum
Caution! Do not use abrasives or steel
wool to clean the drum.

What to do if ...

Troubleshooting by yourself
1)
Problem
Dryer not connected to mains supply.
Dryer does not
work. Loading door opened.
The START PAUSE button not pressed.
Incorrect programme set.
Fluff filters clogged.
Heat exchanger clogged.
Unsatisfactory
Max. loading exceeded.
drying results.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Loading door
Filters not locked in place.
does not close
Err (Error) on
Attempt to change parameters after start of
5)
the programme.
the LCD.
Programme selector in OFF position.
No drum light
Defective light bulb.
26
6 *
7
10
9
Possible cause
Lime in the water or cleaning agents may
form a barely visible lining on the inside of
the drum. The degree to which the laundry has
been dried is then no longer detected reliably.
The laundry is damper than expected when re-
moved from the appliance.
Use a standard domestic cleaner (e.g. vinegar-
based cleaner) to wipe down the inside of the
drum and drum ribs.
Clean control panel and housing
Caution! Do not use furniture cleaners or
aggressive cleaning agents to clean the
machine.
Use a damp cloth to wipe down the control
panel and housing.
Plug in at mains socket. Check fuse in fuse
box (domestic installation).
Close loading door
Press the START PAUSE button.
Set suitable programme.
Clean fluff filters.
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Set suitable water hardness
Install fine filter and/or snap course filter into
place.
Turn the dryer off and on. Set requested pa-
rameters.
Turn it to DRUM LIGHT (if available) or to
any programme.
Replace light bulb (see next section).
Remedy
2)
3)
3)
4)
.
www.zanussi.com