JIMS MILWAUKEE-EIGHT 5833 Instruction Sheet

No.5833-IS
I I n n s s t t r r u u c c t t i i o o n n S S h h e e e e t t F F o o r r T T o o o o l l # # 5 5 8 8 3 3 3 3
J J I I M M S S M M i i l l w w a a u u k k e e e e - - E E i i g g h h t t
® ®
WARNING: DO NOT USE AIR POWERED OR IMPACT TOOLS WHILE
INSTALLING THE BALANCER BEARING OR INSTALLATION PLATE.
SEVERE CASE DAMAGE MAY RESULT.
Tools Required:
5833
JIMS M8 Balancer Bearing Installer
3/4" Wrench or Socket
1/4" allen wrench
9/16" wrench
Only use the supplied hardware during use of this tool. Using different, especially shorter hardware may
cause serious damage to the case and/or case threads.
NOTE: PLEASE READ ALL INSTRUCTIONS COMPLETELY BEFORE PERFORMING ANY WORK!
IF YOU DO NOT KNOW WHAT YOU ARE DOING, DO NOT DO IT!
No information in this instruction sheet pertaining to motorcycle repair is represented as foolproof or even altogether safe.
Even something safe, done incorrectly or incompletely can and will backfire. You and only you are responsible for the safe-
ty of your repair work and for you understanding the application and use of repair equipment, components, methods
and concepts.
Each and every step this tool is designed to do must be carefully and systematically performed safely by you. All informa-
tion listed in this instruction sheet has been tested, re-tested and used daily in JIMS
Department.
ALWAYS WEAR SAFETY GLASSES OR OTHER FACE AND EYE PROTECTION SUCH AS FULL
FACE SHIELD. JIMS
IS NOT RESPONSIBLE FOR THE QUALITY AND SAFETY OF YOUR WORK.
See JIMS
555 Dawson Drive, Camarillo, CA 93012 Phone 805-482-6913 • Fax 805-482-7422
Division of Thiessen Products, Inc.
B B a a l l a a n n c c e e r r B B e e a a r r i i n n g g I I n n s s t t a a l l l l e e r r I I n n s s t t r r u u c c t t i i o o n n s s
® ®
IS NOT RESPONSIBLE FOR DAMAGE, INJURY, OR YOUR WORK. JIMS
®
CAUTION: Wear safety glasses over your eye's.
®
catalog for Hundreds of top quality professional tools.
The last tools you will ever need to buy.
PARTS AVAILABLE SEPARATELY
No. Qty. Description
1 1 BALANCER BEARING INSTALLER PLATE
2 1 BEARING INSTALLER PILOT
3 1 OIL-EMBEDDED THRUST BEARING
4 1 1/2-20 HOLLOW LOCKSET SCREW
5 3 5/16 X 4" SHCS BLACK ALLEN SCREW
6 6 WASHER AN, 5/16"
7 3 5/16-18 NUT
8 1 THREADED INSERT 5/8-18
9 1 SCREW
10 3 5/16-18 X 1-1/2" BLACK ALLEN SCREW
11 1 DOWEL PIN
Scan to watch video.
Note: Video for reference only.
® Research and Development
Rev N/C
7-19
Part No.
5833-1
5833-2
5833-3
5833-4
5833-5
1216
1222
2397
1024
1217
1186-2000
®
1 1