Advertisement
No.5833-IS
I I n n s s t t r r u u c c t t i i o o n n S S h h e e e e t t F F o o r r T T o o o o l l # # 5 5 8 8 3 3 3 3
7. Back the bearing installer pilot #5833-2 out by rotating it counter clockwise, feeling for any
binding between the balancer bearing bore and the balancer bearing pilot. If binding is
detected, loosen the three 5/16-18 x 1-1/2" SHCS #1217 and re-insert the bearing installer
pilot #5833-2 and retighten the SHCS. Repeat until there is no binding.
WARNING: -DO NOT OVER TIGHTEN FASTENERS OR DAMAGE TO THE CASE MAY OCCUR.
-DO NOT FORCE PILOT INTO BORE OR DAMAGE TO THE WILL OCCUR.
-BALANCER BEARING PLATE MUST BE ALIGNED TO BEARING BORE ACCORDING
TO DIRECTIONS BEFORE PRESSING THE BEARING INTO THE CASE OR CASE
DAMAGE WILL OCCUR.
9. Back the Bearing installer Pilot #5833-2 out until it almost touches the Balancer Installer Plate
#5833-1.
10. Lubricate the leading face and outer edge of the bearing (customer supplied) to be installed
with Sunnen Assembly Lube or similar. Place the Balancer Bearing onto the Balancer Bearing
Pilot #5833-2 with the lettering facing upward, and hold in place using your fingers while
turning the Screw #1024 clockwise until the bearing contacts the balancer bearing bore. See
Fig. 8.
See JIMS
555 Dawson Drive, Camarillo, CA 93012 Phone 805-482-6913 • Fax 805-482-7422
Division of Thiessen Products, Inc.
FIG.8
CAUTION: Wear safety glasses over your eye's.
®
catalog for Hundreds of top quality professional tools.
The last tools you will ever need to buy.
Rev N/C
7-19
7 7
Advertisement
