JIMS 5832 Instructions

No.5832-IS
I I n n s s t t r r u u c c t t i i o o n n S S h h e e e e t t F F o o r r T T o o o o l l # # 5 5 8 8 3 3 2 2
M M 8 8 B B a a l l a a n n c c e e r r B B e e a a r r i i n n g g R R e e m m o o v v a a l l I I n n s s t t r r u u c c t t i i o o n n s s

Tools Required:

5832
JIMS M8 Balancer Bearing Puller
T27 Torx
9/16 combination wrench
1-1/8" combination wrench
Deadblow, brass or removable insert hammer
CAUTION:
Wear safety glasses. Excessive force may damage the parts!
1.
Support case half on work bench.
2.
Remove the bearing retainer screw using a T27 Torx. See
3.
Place the slotted end of the Puller, Balancer Bearing M8 No.
the bearing bore. See
4.
Using an insert or small dead blow hammer, tap the bearing puller fully
through the bearing. See
5.
Insert the Dowel Pin No.
5832-1
until it bottoms out against the case. Approximately 3/4 of an inch
should be visible. See
6.
Orient the Bar, Puller No.
5832-1
Bearing M8 No.
7.
Ensure the Bar, Puller No.
8.
Place the ¾" Flat Washer, Brass No.
9.
Screw the ¾-16 Nut No.
NOTE: PLE SE RE D LL INSTRUCTIONS COMPLETELY BEFORE PERFORMING NY WORK!
IF YOU DO NOT KNOW WH T YOU RE DOING, DO NOT DO IT!
No information in this instruction sheet pertaining to motorcycle repair is represented as foolproof or even altogether safe.
Even something safe, done incorrectly or incompletely can and will backfire. You and only you are responsible for the safe-
ty of your repair work and for you understanding the application and use of repair equipment, components, methods
and concepts.
Each and every step this tool is designed to do must be carefully and systematically performed safely by you. All informa-
tion listed in this instruction sheet has been tested, re-tested and used daily in JIMS
Department.
LW YS WE R S FETY GL SSES OR OTHER F CE ND EYE PROTECTION SUCH S FULL
F CE SHIELD. JIMS
IS NOT RESPONSIBLE FOR THE QU LITY ND S FETY OF YOUR WORK.
555 Dawson Drive, Camarillo, CA 93012 Phone 805-482-6913 • Fax 805-482-7422
Division of Thiessen Products, Inc.
Fig.2
Fig.3
5806-4
into the Puller, Balancer Bearing M8 No.
Fig.4
5832-2
with the hole in the Puller, Balancer
and guide the threaded portion through the hole. See
5832-2
is fully supported by the edges of the case.
1099
over the threaded portion of the Puller, Balancer Bearing M8 No.
1098
down clockwise by hand until it meets the brass washer. See
IS NOT RESPONSIBLE FOR D M GE, INJURY, OR YOUR WORK. JIMS
®
FIG.1
Fig.1
5832-1
into
FIG.2
Fig.5
Rev N/C
5832-1
Fig.6
® Research and Development
9-18
.
®
1 1