Advertisement
No.5833-IS
I I n n s s t t r r u u c c t t i i o o n n S S h h e e e e t t F F o o r r T T o o o o l l # # 5 5 8 8 3 3 3 3
5. Place the bearing installer plate #5833-1 in the correct orientation indexed on the case
dowel pin (refer to Fig. 1 for correct placement). Insert the 5/16-18 x 1-1/2" SHCS #1217
and washers (right case) and screw them into the appropriate holes (Marked "F" for front
case, and "R" for the rear of the case) snug, and back off 1/8 turn, see Fig. 6.
6. Align the bearing installer pilot #5833-2 with the balancer bearing bore and carefully lower
the bearing installler pilot by rotating the screw #1024 clockwise until it bottoms out in the
balancer bearing bore, back off 1/4 turn. DO NOT force the pilot into the bore or case dam-
age may result. Tighten the three 5/16-18 x 1-1/2" SHCS #1217 until tight with an Allen
key. See Fig. 7.
See JIMS
555 Dawson Drive, Camarillo, CA 93012 Phone 805-482-6913 • Fax 805-482-7422
Division of Thiessen Products, Inc.
FIG.7
CAUTION: Wear safety glasses over your eye's.
®
catalog for Hundreds of top quality professional tools.
The last tools you will ever need to buy.
FIG.6
Rev N/C
7-19
6 6
Advertisement
