Operating Your Refrigerator - Beko DNE 65000 E Manual

Operating your refrigerator

Before you start using the fridge/freezer check the
following:
1. Have the feet been adjusted so that the product
stands level?
2. Is the interior of the refrigerator dry and can the
air circulate freely in the rear of it?
3. Clean the interior of the refrigerator as
recommended in the "Cleaning your refrigerator"
section.
4. Plug the refrigerator into the wall outlet.
• When the door is open the respective interior
light will come on.
5. You will hear a noise as the compressor
starts up. The liquid and gases sealed within the
refrigeration system may also give rise to noise,
even if the compressor is not running and this is
quite normal.
Due to the operation of fans inside the
appliance, overall noise level is slightly
higher in comparison to non-frost free
appliances. This is quite normal and is not a
fault.
6. Front edges of the refrigerator may feel warm.
This is normal. These areas are designed to be
warm to avoid condensation.
7. Do not fill the interiors of the refrigerator in initial
operation for the first 12 hours.
8. When the compartments reach the desired
temperatures fans will stop.
9. Especially pay special attention to prevent the
foodstuffs, in particular, small pieces, such as
rice, peas and beans from running into the fan
protectors and air flow ducts. These may cause
clogging of the cooling system and a decrease in
the efficiency of the device.
10. The compressor will start running
approximately 5 minutes after the refrigerator is
plugged in to protect the electronic components
of your appliance. After startup of the compressor,
compartment temperatures will reach to the
setup temperatures in 24 hours depending on
the ambient temperature and load status of your
refrigerator.
11. Pay attention to the following points during the
first 24 hours of the operation:
• Do not open the doors frequently.
• Do not overload your refrigerator.
• Do not put hot food.
EN
8