GENERAL Wet Well Level Control: Sump level is controlled by Myers switch controls. The float is held in position Shipping: When unpacking unit, check for concealed in the sump by a weight attached to the power cord damage. CLAIM FOR DAMAGE MUST BE MADE AT above the float.
Page 3
factory water testing, so it must be broken loose with connections are tightened. The use of expansion a small bar or screwdriver in the edge of the vanes. joints or vibration pads does not preclude the need to The impeller must turn freely. properly support the piping.
Page 4
Discharge-Outlet Piping: The discharge piping for More distance between turn-on and turn-off short runs can be of the same size as the discharge of controls can be used, but sewage may become the pump. It is recommended that longer runs be 1 to septic, and excessive solids may collect for the 2 sizes larger depending on the length.
PUMP OPERATION Servicing Instructions: Starting System: IMPORTANT: Read all instructions prior to 1. Turn H-O-A switch to Off position and then turn on replacing any parts. main circuit breakers. 2. Open all discharge valves and allow water to rise in WARNING: Before handling these pumps wet well.
Pump does not deliver proper capacity. 13. Examine all O-rings for nicks before using and replace damaged O-rings with new ones. 1. Discharge gate valve may be partially closed or 14. Use Loctite on socket head impeller locking partially clogged. ®...
STANDARD LIMITED WARRANTY Myers warrants its products against defects in material and workmanship for a period of 12 months from the date ® of shipment from Myers or 18 months from the manufacturing date, whichever occurs first - provided that such products are used in compliance with the requirements of the Myers catalog and technical manuals for use in pumping raw sewage, municipal wastewater or similar, abrasive free non-corrosive liquids.