Installation Instructions; Requirements; Tools And Parts - Whirlpool WEG745H0F Owner's Manual

7. If any soils remain, remove them with a nonscratch scrubbing
sponge or plastic scraper. Additional Clean cycles may be run
to help remove the stubborn soils.
IMPORTANT: Do not use oven cleaners. The use of
chemicals, including commercial oven cleaners or metal
scouring pads, may cause permanent damage to the
porcelain surface of the oven interior.
NOTE:
� The range should be level to ensure that the entire surface
of the bottom of the oven cavity is covered by water at the
beginning of the Clean cycle.
� For best results, use distilled or filtered water. Tap water
may leave mineral deposits on the oven bottom.
� Before removing the residual water and loosened soils at
the end of the Clean cycle, insert a cloth or paper towel
between the lower edge of the oven door and the front
frame to keep water from spilling onto the front of the
range and the floor.
� Soil baked on through several cooking cycles will be more
difficult to remove with the Clean cycle.
� Nonabrasive scrub sponges or eraser-style cleaning pads
(without cleaners) can be effective for cleaning the oven
cavity walls, oven door, and oven bottom for difficult soils.
For best results, moisten the pads and sponges before
use.
� Run an additional Clean cycle for stubborn soils
� Affresh ®
Kitchen Appliance Cleaner and affresh
Cleaner may be used to clean the oven bottom, walls, and
door when the oven has finished the cycle and returned to
room temperature. If affresh
is recommended to wipe out the cavity with distilled water
as well. Refer to the Quick Start Guide for ordering
information.
� Additional AquaLift
®
obtained by ordering Part Number W10423113RP. Refer to
the Quick Start Guide for ordering information.
† ®
QUADREX is a registered trademark of NLW Holdings, Inc.
8
®
Cooktop Cleaner is used, it
Technology Cleaning Kits may be

INSTALLATION INSTRUCTIONS

REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
� Tape measure
� Flat-blade screwdriver
� Phillips screwdriver
� 1/8" flat-blade screwdriver
� Level
� Hand or electric drill
� Hammer
� Wrench or pliers
� Pipe wrench
� 15/16" combination wrench
� 1/4" drive ratchet
� 3/8" nut driver
� 1/8" drill bit (for wood floors)
� Marker or pencil
� Pipe-joint compound
®
Cooktop
resistant to Propane gas
� Noncorrosive leak-detection
solution
Parts Supplied
Check that all parts are included.
� Propane/Natural Gas Conversion Kit
� #10 x 1
� Anti-tip bracket (inside oven cavity)
Anti-tip bracket must be securely mounted to the back wall or
floor. Thickness of flooring may require longer screws to anchor
bracket to subfloor. Longer screws are available from your local
hardware store.
Parts needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See "Electrical Requirements" and
"Gas Supply Requirements" sections.
IMPORTANT: When the range is used under microwave models:
JMC82808CB-0, JMV9196CB-0, or YJMV9196CB-0, the Door
Baffle Plate Part Number W10737014 must be ordered and used.
Please reference the Quick Start Guide for contact information.
Optional parts
To purchase these or any other accessories, please reference the
Quick Start Guide for contact information.
� Side Trim Kits:
5/8" (1.7 cm) White - Order Part Number W10675027
5/8" (1.7 cm) Black - Order Part Number W10675026
5/8" (1.7 cm) Stainless Steel - Order Part Number W10675028
1 1 / " (2.9 cm) White - Order Part Number W10731885
8
1 1 / " (2.9 cm) Black - Order Part Number W10731886
8
1 1 / " (2.9 cm) Stainless Steel - Order Part Number W10731887
8
� Backsplash Kits:
High 6" (15.2 cm) White - Order Part Number W10655448
High 6" (15.2 cm) Black - Order Part Number W10655449
High 6" (15.2 cm) Stainless Steel - Order Part Number
W10655450
� 3/16" carbide-tipped
masonry drill bit
(for concrete/ceramic floors)
(For Slide-in/Front Control
Ranges)
For Propane/Natural Gas
Conversions
� 3/8" combination wrench
� 1/2" combination wrench
� 5/8" combination wrench
� 9/32" nut driver
� Quadrex
screwdriver
� Masking tape
� 3/8" nut driver
(For Slide-in/Front Control
Ranges)
5 / " (4.1 cm) screws (for mounting anti-tip bracket) (2)
8
® or Phillips
†