8.
On the back of tower sides (The front of the tower is designated by the
nameplate on the tower bottom shelf), center tower bracket in space
between 1st & 2nd groove at top location
9.
Center tower bracket between 8th & 9th groove for middle location.
10. Center tower bracket between 2nd groove & bottom for bottom location.
11. Repeat for opposite side (3 per side).
12. Secure tower bracket using #6 3/4 in. screw.
STEP 2 - Attaching Tower To Wall
1.
Measure up from the floor & mark desired height location (Towers are typi-
cally placed at 84 in.).
2.
Draw a 2 ft. level line at your marked location (This represents the location
of the tower top).
2
You will space 2 L clips equidistant within the 24in. level line.
(It is recommended to use wall studs or a minimum of 1 side into wall
studs. If no stud is present, use wall anchors provided.)
3.
Center L clip to screw hole with the level line & mark hole locations.
4.
Install wall anchors if no stud is present.
5.
Secure L clip to the wall using # 8 1 1/2 in. screws at hole locations.
6.
Repeat for remaining L clip location.
7.
Place tower onto L clip hardware.
8.
Place level against tower side & plumb level tower.
9.
Mark tower bracket hole locations.
10. Remove Tower.
11. Install wall anchors if no stud is present.