Furuno NBDP DP-6 Installation Manual page 18

Post BK
NOTE: For further details about BK timing and mute timing, see
page 14.
Modem Output Level Adjusts output signal from the modem, be-
MIF Command
Tune*
Freeze*
AGC*
Emission*
TX/RX MSG Save
Edit before Sending
*: These commands are available according to a model connected.
Sets the timing for the trailing edge of the
mute signal.
tween -30 and +10 dBm. Refer to operation's
manual of radiotelephone connected. With
FURUNO radiotelephone, the default set-
ting is available.
With FURUNO transmitter connected, ON
sends antenna coupler tuning command.
With FURUNO radio equipment connected,
ON sends "freeze" command to disable con-
trols of radio equipment.
Turn on for radio equipment which supports
AGC command in the MIF format, so that
the gain is automatically controlled in the
telex mode.
ON sends EM (emission) command to ra-
diotelephone.
An outgoing or incoming message can be
saved automatically to a floppy disk.
OFF: Transmits keying operation one by
one.
ON: Transmits message only when the
ENTER key is pressed.
13