Digital Input Dipshunt Configuration - ABB Symphony Harmony Series Instruction

WBPEEUI240769B0
Table A-3. Analog Output Dipshunt Configuration
Application/Signal Type
Output 1 in current mode, output 2 in
voltage mode
Both outputs in current mode (no
dipshunt required)
Table A-4. Digital Input Dipshunt Configuration
Application/Signal Type
System powered E3/E4
1
Field powered
NOTE:
1. Using the field device to complete the path to ground is commonly referred to as switching neu-
tral. Using the field device to complete the path to the I/O module is referred to as switching hot. If
switching hot is the desired method, the field powered dipshunt configuration must be used. If sys-
tem power is required, it should be wired as a field source. Refer to Figure
switching hot and switching neutral.
(continued)
Dipshunt Configuration XU9
1 2 3 4 5 6 7 8
T0 3907 A
1 2 3 4 5 6 7 8
T0 3908 A
Dipshunt Configuration XU5-XU7
1 2 3 4 5 6 7 8
T0 3909 A
1 2 3 4 5 6 7 8
T0 3910 A
A-2 for an example of
Introduction
A - 5