Parameter List - ABB Relion 615 Series Protocol Manual

Section 4
DNP3 parameters
4.2
Table 10: DNP3 settings
Parameter
DNP physical layer
Unit address
Master address
Serial port
Need time interval
Time format
CROB select timeout
Data link confirm
Data link confirm TO
Data link retries
Data link Rx to Tx delay
Data link inter char delay
App layer confirm
App confirm TO
App layer fragment
Table continues on next page
22
Deadbanding of the analog static values cannot be set in DNP3. Event generation is
dependent on the functions employed in the IED, and the execution loops these
functions belong to. See the IED's technical manual for setting deadbands.
As a result of the event generation mechanism in the IED, the events reported by
DNP3 are very accurate and are the same events that can be retrieved over the
WHMI or other protocols such as IEC 61850-8-1.
Power must be cycled to the unit after making changes to the DNP3
parameters. The LHMI or WHMI will not notify the user that this
action must be taken. Only one session is allowed to place the unit
in write (edit) mode.

Parameter list

The DNP3 parameters can be accessed with PCM600 or via the LHMI path
Configuration/Communication/DNP3.0.
Values (Range) Unit
1=Serial
2=TCP/IP
1...65519
1...65519
0=Not in use
1=COM 1
2=COM 2
0...65535 min
0=UTC
1=Local
1...65535 sec
0=Never
1=Only Multiframe
2=Always
100...65535 ms
0...65535
0...255 ms
0...20 char
1=Disable
2=Enable
100...65535 ms
256...2048 bytes
Step Default
2=TCP/IP
1 1
1 3
0=Not in use
1 30
1=Local
1 10
0=Never
1 3000
1 3
1 0
1 4
1=Disable
1 5000
1 2048
1MRS756709 D
Description
DNP physical layer
DNP unit address
DNP master and UR address
COM port for serial interface, when
physical layer is serial.
Period to set IIN need time bit
UTC or local. Coordinate with master.
Control Relay Output Block select timeout
Data link confirm mode
Data link confirm timeout
Data link retries count
Turnaround transmission delay
Inter character delay for incoming
messages
Application layer confirm mode
Application layer confirm and UR timeout
Application layer fragment size
Communication Protocol Manual
615 series