Special Features - Bissell 1867 User Manual

A
ssembly
1. Attach lower body to swivel head.
2. Secure swivel head with small Phillips head
screw. Tighten until secure.
3. Slide handle assembly down into lower body
until it will go no further.
4. Secure the handle by placing the large
Phillips head
opening in the lower body and into the rear
of the handle assembly. Tighten with
screwdriver until secure.
5. Slide water tank onto lower body by lining up
vertical glides and gently sliding tank into place.
Steam Mop assembly is now complete.
S
pecial features
Water tank
The water tank is located on the back of the
Steam Mop. It can be refilled with water any time
during use. Distilled or demineralized water may
be used in place of tap water.
Do not use chemicals with your Steam Mop.
Water filter
This filter removes minerals and other impurities
from tap water, preventing water deposits from
damaging your Steam Mop. It should be replaced
when the bright green grains turn blue. To maximize
performance of the filter, distilled water may be used.
Ready light
The ready light will glow when tap water has
been converted to steam and the Steam Mop is
ready to use.
Trigger
Press to release steam.
Swivel head
Allows you to clean in tight spaces and under
cabinets.
Mop pad
Reuseable microfiber mop pad is machine
washable and safe for all hard floor surfaces.
6
w w w . b i s s e l l . c o m
ug010-4520_1867_607.indd 6 ug010-4520_1867_607.indd 6
screw through the screw
1 2
3 4
5
Tip:
Do not attempt to use
your Steam Mop without
water in the tank.
8 0 0 . 2 3 7 . 7 6 9 1
6/29/07 11:42:04 AM 6/29/07 11:42:04 AM