Special Features; Water Filter - Bissell 1867 SERIES User Manual

A
ssembly
1. Attach lower body to swivel head.
2. Secure swivel head with small Phillips head
screw. Tighten until secure.
3. Slide handle assembly down into lower body
until it will go no further.
4. Secure the handle by placing the large
Phillips head
opening in the lower body and into the rear
of the handle assembly. Tighten with
screwdriver until secure.
5. Slide water tank onto lower body by lining up
vertical glides and gently sliding tank into place.
Steam Mop assembly is now complete.
S
pecial features
Water tank
The water tank is located on the back of the
Steam Mop. It can be refilled with water any time
during use. Distilled or demineralized water may
be used in place of tap water.
Do not use chemicals with your Steam Mop.

Water filter

This water water filter removes minerals and other
impurities from tap water, preventing water depos-
its from damaging your Steam Mop. It should be
replaced when the bright green grains turn blue. To
maximize performance of the water water filter, dis-
tilled water may be used.
Ready light
The ready light will glow when tap water has
been converted to steam and the Steam Mop is
ready to use.
Trigger
Press to release steam.
Swivel head
Allows you to clean in tight spaces and under cabinets.
Microfiber Mop pad
Reuseable microfiber mop pad is machine
washable and safe for all hard floor surfaces.
6
w w w . b i s s e l l . c o m
ug120-4008_1867E_807.indd 6 ug120-4008_1867E_807.indd 6
screw through the screw
1 2
3 4
5
Tip:
Do not attempt to use
your Steam Mop without
water in the tank.
8/20/07 10:13:10 AM 8/20/07 10:13:10 AM