CDVI BO600RH Installation Manual page 4

INSTALLATION MANUAL
BO600RH
Horizontal retrofi t housing
4] ASSEMBLY
Position the box-section backplate, complete with pre-
fi tted electro-magnetic locks, on to the door frame -
ensure the positioning will allow for the architectural
handle to close securely over the section. Once you
are satisfi ed with the position, mark the vertical
and horizontal holes, then drill as required. Take
note of the cable entry holes, and feed the cables
through. Fix the section into place, then wire the
electromagnetic locks in accordance with the wiring
schematic in Section 5. Fit the box section cover
into place, fi x the end caps and secure with the M4
screws provided. To fi nalise the assembly, tighten
all fi xings, and protect the handle fi xing section by
fi tting the cover and end caps.
cdvi.com
4
cdvigroup.com
With the door closed, position the architectural
handle onto the edge of the opening leaf of the door,
ensuring the handle covers the box-section. Mark
the vertical and horizontal holes, drill as required,
then temporarily fi x the handle leaving a small gap
around the box section – check the alignment of the
magnets in the box section with the armatures in
the handle. Adjust if necessary, then once satisfi ed,
secure the handle by completing the fi xings.
Insert the end caps and secure.
EN