Biostar M7VIG User Manual page 65

Chapter 2
State After Power Failure
This field determines the action the system will automatically take when power is
restored to a system that had lost power previously without any subsequent manual
intervention. There are 3 sources that provide current to the CMOS area that retains
these Power-On instructions; the motherboard battery (3V), the Power Supply
(5VSB), and the Power Supply (3.3V). While AC is not supplying power, the
motherboard uses the motherboard battery (3V). If AC power is supplied and the
Power Supply is not turned on, 5VSB from the Power Supply is used. When the
Power Supply is eventually turned on 3.3V from the Power Supply will be used.
Wake Up/ Power On Control
If you highlight the literal "Press Enter" next to the "Wake Up/ Power On Control"
label and then press enter key, it will take you to a submenu with the following
options:
Power On by PCI card
When you select Enabled, a PME signal from PCI card returns the
system to Full On state.
The Choices: Disabled (default), Enabled.
Wake Up on LAN/Ring
An input signal on the serial Ring Indicator (RI) line (in other words,
an incoming call on the modem) awakens the system from a soft off
state.
The Choices: Disabled (default), Enabled.
RTC Alarm Resume
This function is for setting date and time for your computer to boot up.
During Disabled, you cannot use this function. During Enabled,
Choose the Date and Time Alarm:
Date (of Month) Alarm You can choose which month the system
Time (hh:mm:ss) Alarm You can choose shat hour, minute and
Note: If you have change the setting, you must let the system boot
up until it goes to the operating system, before this function will
work.
The Choices: Auto, On, Off (default).
will boot up.
second the system will boot up.
2-26
BIOS Setup