F) Loading Factory Settings; G) Reset; H) Focussing - Renkforce 1233874 Operating Instructions Manual

Display alignment
• Push the button ESC (7) repeatedly until rdoF or rdon appears.
• Select the desired display alignment with the buttons UP (8) or DOWN (9) and confirm your input with the
button ENTER (10).
rdoF = normal display alignment
rdon = inverted display direction

f) Loading Factory Settings

After comprehensive changes to the configuration, it may be necessary to reset the device to factory
settings. For this, perform the following steps.
• Press ESC (7) repeatedly until dFoF appears.
• Select dFon with the buttons UP (8) or DOWN (9) and confirm your input with the button ENTER (10).
• The internal controller loads the factory settings.

g) Reset

In case of function interferences, you may need to restart the moving head. For this, perform the following
steps.
• Press ESC (7) repeatedly until rSt appears.
• Press the ENTER button (10) to confirm your input.
• The internal controller restarts the moving head. During starting, the message rSt is displayed.

h) Focussing

In order to display the projection sharp on the projection area, the focus at the emission lens must be set.
For this, turn the lens at the light exit until a set gobo is presented sharply on the projection area.
33