Factory Default Settings; Web Interface (Username And Password); Device Lan Ip Settings; Isp Setting In Wan Site - Billion BiPAC 7402NX User Manual

Factory Default Settings

Before configuring your, you need to know the following default settings.

Web Interface (Username and Password)

Username: admin
Password: admin
The default username and password are "admin" and "admin" respectively.
If you ever forget the username/password to login to the router, you may
press the RESET button up to 6 seconds to restore the factory default
settings.
Caution: After pressing the RESET button for more than 6 seconds, to be sure you power
cycle the device again.
Attention
Attention

Device LAN IP settings

IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0

ISP setting in WAN site

PPPoE

DHCP server

DHCP server is enabled.
Start IP Address: 192.168.1.100
IP pool counts: 100

LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.
LAN Port
IP address
Subnet Mask
DHCP server function
IP addresses
distribution to PCs
Chapter 3: Basic Installation
Billion BiPAC 7402NX(L) 802.11n 3G/ADSL2+ (VPN) Firewall Router
192.168.1.254
255.255.255.0
Enabled
for 100 IP addresses continuing from
192.168.1.100 through 192.168.1.199
WAN Port
The PPPoE function is enabled
to automatically get the WAN
port configuration from the ISP.
16