Ethernet - Billion BiPAC 7402NX User Manual

You can setup member ports for each VLAN group under Bridge Interface section. From the example, two
VLAN groups need to be created.
Ethernet: P1 and P2 (Port 1, 2).
Ethernet1: P3, P4 and Wireless (Port 3, 4, Wireless). Uncheck P3, P4 and Wireless from Ethernet VLAN
port first.
Note: You should setup each VLAN group with caution. Each Bridge Interface is arranged in this order.
Bridge Interface

ethernet

ethernet1
ethernet2
ethernet3
ethernet4
Management Interface: To specify which VLAN group has possibility to do device management, like
doing web management.
Note: NAT/NAPT can be applied to management interface only
Ethernet
Primary IP Address
IP Address: The default IP on this router.
Subnet Mask: The default subnet mask on this router.
RIP: RIP v1, RIP v2, and RIP v2 Multicast. Check to enable RIP function.
Chapter 4: Configuration
Billion BiPAC 7402NX(L) 802.11n 3G/ADSL2+ (VPN) Firewall Router
VLAN Port (Always starts with)
P1 / P2 / P3 / P4 / Wireless
P2 / P3 / P4 / Wireless
P3 / P4 / Wireless
P4 / Wireless
Wireless
30