Warnings And Cautions - Intertek 990-3075 Manual

Wall mounted electric fireplace with remote control
Table of Contents

Advertisement

Available languages

Available languages

Important safety instructions
When using this electrical appliance, basic precautions must be followed to reduce the risk
of fire, electric shock, and injury to a person, including the following :
Do not switch the appliance ON until it is properly installed as described in this
manual.
Do not leave the appliance unattended during use.
Keep out of reach of children and do not allow them to operate this appliance.
From time to time, check the cord for damage. Never use the appliance if the cord or
any part of the appliance shows signs of damage.
Repairs to electrical appliances should only be performed by a qualified electrician.
Improper repairs may place the user at serious risks.
Do not run the cable under carpets, rugs etc.
Do not allow the mains cable to hang over sharp edges or come into contact with hot
surfaces.
WARNING: In order to avoid overheating, do not cover or obstruct the heater in any
way.
Never immerse the product in water or any other liquids.
LED Bulb Replacement
Note: The flame effect of this electric fireplace is created by LED Bulbs.
The life of these LED bulbs will be 100 000 hours. The users are not recommended to
replace the LED Bulbs. For any reason should the bulbs stop working properly, contact a
qualified technician.
-9-
Cleaning:
Turn the heater OFF and unplug from the electrical outlet before any cleaning or
maintenance is performed. Wait at least 10 minutes to allow all components to cool
down properly.
Use a vacuum or duster to keep the heater and the vent area clean from dust and dirt.
The exterior of the fireplace should be cleaned with a damp cloth or a duster.
Do not use abrasive cleaners or liquid sprayers.

WARNINGS AND CAUTIONS

WARNING : To avoid electrical shocks, do not open the back panel of the element
unless the power has been turned off and unplugged.
WARNING : Any electrical repairs to this electric fireplace should be
performed by a qualified technician.
WARNING : Any electrical wiring repairs should only be performed by a qualified
technician and must comply with local buildings codes.
WARNING : Discontinue use of this electric fireplace if any of the following has
occurred : Water damages, if the element is dented, if the power cord is
broken, if power cord becomes hot to touch, if unit smokes or
smells like smoke.
Note: When the heat function is used for the first time, a slight odor may be
present. This is normal and should not occur again, unless the heater is not
used for an extended period of time and that dust is allowed to accumulate
on the heater element.
Technical specification
Supply : 120V/60Hz
Rated power :750W/1500W
-10-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents