Advertisement
⚫
Do not run the cable under carpets, rugs etc.
⚫
Do not allow the mains cable to hang over sharp edges or come into contact with hot
surfaces.
⚫
WARNING: In order to avoid overheating, do not cover or obstruct the heater in any
way.
⚫
Overheating will result if it is accidentally covered.
⚫
Never immerse the product in water or any other liquids.
LED Bulb Replacement
Note: The flame effect on this electric fireplace insert is created by LED Bulbs.
The life of these LED bulbs will be 100,000 hours. The users are not recommended to
Replace the LED Bulbs. For any reason should the bulbs stop working properly, contact a
Qualified technician.
Cleaning:
⚫
Turn heater OFF and unplug from electrical outlet before any cleaning or maintenance
is performed. Wait at least 10 minutes to allow all components to cool properly.
⚫
Use a vacuum or duster to keep heater and vent area clean from dust and dirt.
⚫
The exterior of the fireplace should be cleaned with a damp cloth or duster.
Do not use abrasive cleaners or liquid sprays.
WARNINGS AND CAUTIONS
WARNING To avoid electrical shock not open the back panel of the insert unless
the
Power has been turned off. And the insert has been unplugged.
WARNING
Any electrical repairs.to this electric fireplace. Should only be
Performed by a qualified technician.
WARNING
Any electrical wiring repairs should only be performed by a qualified
Technician. And also must comply with local buildings codes.
WARNING
Discontinue use of this electric fireplace if any of the follow has
-11-
Occurred: Water damage. If insert has been or dented. If power cord has
Become broken. If power cord becomes hot to touch, if unit smokes or
Smells like smoke.
Note:
When the heat functions is used for the first time. A slight odor may be
Present. This is normal and should be occur again unless heater is not used
For extended periods of time and dust is allowed to accumulate on heater
Element.
Technical Specification
⚫
Supply: 120V/60Hz
⚫
Rated power:750W/1500W
Meaning of crossed - out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection
facilities.
Safety Cut-Off
⚫
This appliance is fitted with a safety cut-off which will operate if the fire overheats
(e.g. due to blocked air vents) .For safety reasons, the fire will NOT automatically
reset.
⚫
To reset the appliance, disconnect the appliance from the mains supply for at least 15
minutes. Reconnect the supply to the mains and switch on the appliance.
Troubleshooting
Symptom
No operation/no fan,
Check fuse by replacement,
Check for safety cut-off operation,
No fire effect light,
Check the LED light with technician.
Solution
-12 -
Advertisement
