Table of Contents
Advertisement
Indicator Lights
29
30
31
• Remove and empty the tray and the coffee collector. Put these parts back
in position.
The «ground coffee» indicator light flashes.
• Press again on the control
After approx 5 mins the «empty collector» indicator light comes on again.
After emptying the tray, press the control
After approx 2 mins the «empty collector» indicator light comes on yet again.
Empty the tray and the collector and then put them back.
A rinse cycle is necessary to complete the cleaning programme.The «rinse»
indicator light comes on.
• Press the control
. After rinsing, the cleaning programme is finished and all
the indicator lights go out.
• Remove the tray and the coffee collector. Clean these parts in hot water and
washing-up liquid. Rinse and dry the parts then replace them.
20
KRUPS
• Start the cleaning programme by pressing the
control for about 3 seconds (29).
The indicator lights «on/off», «empty
collector» and «clean» are lit.
• Empty the tray and the coffee collector then
replace them.
The indicator light «on/off» and «clean» are
on and the «ground coffee» indicator light
flashes.
• Open the lid of the channel for ground coffee
and drop in a KRUPS cleaning tablet. Leave
the lid open throughout the cleaning
programme (30).
• Press the control
(31) again.
At intervals, the pump draws in water, and then
ejects it into the tank via the coffee outlets.
During these operations, the «clean» indicator
light flashes.
After a few moments, (approx 7 mins) the
operation stops and the «empty collector»
indicator light comes on, and the «clean»
indicator light is lit.
.The cleaning programme continues.
to continue the cleaning programme.
Note!
If, when the programme starts, there is not enough water in
the tank, you will be warned of this by the fact that the «fill
water tank» indicator light comes on.
Add water to the tank and cleaning will continue automatically.
If the tray is not in place you will be warned of this by the
flashing of the «empty collector» indicator light. Put back
the tray for the cleaning programme to continue automatically.
If you activate the steam/not water selector by mistake, you
will be warned of this by the flashing of the «on/off» and
«steam» indicator lights. Return the selector to the position
for the cleaning programme to continue automatically.
If you press the control
during cleaning or if there is a
power cut, the cleaning programme has to be started again
right from the beginning. If this happens, another cleaning
tablet will be needed.
3. Descaling
As soon as the «descale» indicator light comes on, you should perform the
descaling procedure.The descaling programme takes about 35 minutes.
Note!
You can continue to use the appliance, but you should descale
it as soon as possible.
Warning!
Use only KRUPS descaling products, citric acid or tartaric acid.
No liability can be accepted for any damage to the appliance
caused by the use of other products. Descaling products are
available from KRUPS authorised service dealer –
0121 200 2740.
You must never, under any circumstances, use classic
amidosulphonic acid or other products containing this acid as
you risk damaging the appliance.Take care to check the
composition of the descaling products which you intend to use.
Proceed as follows:
The appliance must be plugged in, but do not switch it on.
The steam/hot water selector must be in the position
• Fill the water tank with precisely 1/2 litre of warm water and dissolve
4 tablespoons (approx 40g) of the descaling product or a sachet of KRUPS
descaler. Replace the water tank.
Indicator Lights
.
21
KRUPS
Advertisement
Table of Contents
