Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Lifetime Manuals
  4. Sports & Outdoors
  5. 12347
  6. Owner's manual

Lifetime 12347 Owner's Manual

Hide thumbs Also See for 12347:

Advertisement

Quick Links

Download this manual
For Cemented, In-Ground Systems Only

Advertisement

loading
Need help?

Need help?

Do you have a question about the 12347 and is the answer not in the manual?

Questions and answers

Related Manuals for Lifetime 12347

Summary of Contents for Lifetime 12347

  • Page 1 For Cemented, In-Ground Systems Only...
  • Page 2 Maintaining your privacy is our long-standing policy at Lifetime. And you can rest assured that Lifetime will not sell or provide your personal data to other third parties, or allow them to use your personal data for their own purposes.

  • Page 3: Safety Instructions

    WARNING To ensure your safety, do not attempt to assemble this system without reading and following all instructions carefully. Identify and inventory the parts using the Parts List. Failure to comply with any of the warnings in these instructions may result in serious personal injuries such as cuts, broken bones, nerve damage, paralysis, brain injury, or death.

  • Page 4: Parts List

    PARTS LIST Part # Description qty. 1029635 Tube, Swaged 1029636 Tube 1029563 1029561 Weight Bag Net Hardware (1029637) BN00300 1/4”-20 Cap Nut 1029478 1/4”-20 x 1 3/4” Hex Bolt 1029479 1/4” Flat Washer 1029560 Harness 1031424 6 mm Screw 1031444 1”...
  • Page 5 HARDWARE IS ACTUAL SIZE (*Unless otherwise indicated) Swaged end...
  • Page 6 Required For This Page: Screwdriver 1029637 1. Insert Swaged Tube (AA) into Tube (AB). 2. Secure the Tube Assembly together using one (1) 6 mm Screw (NE). 3. Insert a 1” Plug (NF) into each end of the Tube Assembly. 4.
  • Page 7 Required For This Page: 7/16” Wrenches (12) 1029637 5. Secure the Tube Assembly to the Net using one (1) 1/4”-20 x 1 3/4” Hex Bolt (NB), two (2) 1/4” Flat Washers (NC), and one (1) 1/4”-20 Cap Nut (NA) for each hole. WARNING Do not overtighten the Cap Nut.
  • Page 8 Required For This Page: 1029637 6. Insert the straps of the Harness (ND) under and around the Tube Assembly as shown. 7. Pull the straps of the Harness up through both the first and second rings. Finally, loop the strap around Ring 2 and back through Ring 1 (as shown below). Repeat for second strap.
  • Page 9 9. Lower your rim to its lowest setting. WARNING: If using a ladder during assembly, use extreme caution. 10. Loop the Harness over the rim and pull down on the straps until the Net fits snug against the back of the rim next to the backboard.
  • Page 10 Required For This Page: 1029637 13. Completely fill Weight Bags (AD) with sand (approximately 30 lb. each) and zip closed. 14. Connect one end of the Bungee Cords (NG) to Weight Bags and the other end to the bottom corners of the Net. 15.
  • Page 11 Notes:...
  • Page 12 All merchandise is sold on this condition, and no representative of the company may waive or change this policy. 5. This product is not intended for institutional or commercial use; Lifetime Products, Inc. does not assume any liability for such use. Institutional or commercial use will void the warranty.