Parkair Energy Solutions MCW 2.0 User And Installation Manual page 37

Performance referred to the following conditions:
Indoor unit temperature test conditions: Cooling: indoor 27°C dry bulb; Heating: indoor 20°C dry bulbB.
COP: 100% capacity with 15°C inlet / 30°C outlet; EER: 100% capacity with 10°C inlet / 7°C outlet. Water flow
with tap water at the following temperatures: Summer 15°C inlet / 40°C outlet; Winter 15°C inlet / 4°C outlet.
The sound pressure level refers to 1 mt. away from the external surface of the unit operating in the open field.
2-2 BEFORE PROCEEDING IN INSTALLATION
Before installing the equipment, carefully read and
keep the user manual and the general conditions of
the manufacturer below.
1. Make sure that the equipment corresponds to the
needs of the system.
2. Check that the flow rate of the cooling water is
sufficient for the correct operation of the system.
3. Check that the refrigerant and hydraulic pipes are
correct according to the manufacturer's instructions.
4. Install the supplied water filter to protect the plate
heat exchanger (water inlet).
5. In the event of impurities present in the water,
perform periodic maintenance on the filter.
6. Make sure that the correct voltage reaches
the electrical connection terminals (see the
identification plate attached to the appliance). An
incorrect voltage would irreparably compromise
the main components of the equipment.
7. If alarms should be triggered, consult the user
manual or contact the Technical Assistance Center
of the manufacturer.
8. Do not force the operation of the machine for
any reason by tampering with or altering the safety
devices inside.
9. It is not possible to make start-ups with incomplete,
temporary or precariously mounted systems.
10. The connections to the machine (hydraulic
and electrical) must be carried out by expert and
competent personnel and must meet all the safety
and health protection standards in force at the time
and in the country in which you operate.
11. The technical documentation (diagrams and
user manual) must be kept in good condition in an
easily accessible place for a quick consultation in
case of need.
12. The equipment must not be used for purposes
that do not correspond to the characteristics for
which it was built.
13. Respect the technical spaces indicated in
this manual to ensure good access to machine
maintenance.
14. In case of damage to the equipment caused
by failure to observe the points indicated above
or the information contained in this booklet, the
manufacturer reserves the right to partially or totally
cancel the warranty.
15. For any clarification, please contact our technical
department (see paragraph 6.2).
37