Description Of Product; Installation - Yard force AQUAJET LW C02 Original Instructions Manual

DESCRIPTION OF PRODUCT

Parts description (Fig. A)
1. Lance
2. Eco/Pressure Switch Button
3. Safety Lock Button
4. Battery Pack
5. ON/OFF Switch Trigger
6. Handle Rotary Lock Button
7. Water Inlet/ Hose Connector
8. 3 in 1 Nozzle
Check the delivery parts (Fig. B)
Remove the appliance from its packaging carefully and make sure that all of the
following parts are present:
a. 3 in 1 nozzle
b. AQUAJET housing
c. Hose
d. Water filter
e. Lance
f. Battery pack
g. Charger
h. Foam sprayer
i. Net bag
j. Brush
k. Instruction manual
l. Quick start guide
m. Foldable bucket
WARNING: If any parts are damaged or missing, do not operate
this tool until these parts have been replaced. Failure to heed this
warning could result in serious personal injury.
NOTE: Always recycle the packaging in accordance with local
.
recycling guidelines
22

INSTALLATION

Install the lance (Fig. C)
Align the lance to the main housing and push down firmly and then rotate the lance to secure
in place.
NOTE
: Make sure that the lance button is position on the top side.
Fitting the 3 in 1 nozzle (Fig. D)
press and hold down the lance nozzle lock button and then align the nozzle spigot and
assemble into the lance and release the lock button.
Choose your water source (Fig. E)
1. Using the Aquajet with your garden hose pipe – attach the hose pipe to the Aquajet
connector and make sure that it is locked into position
2. Using the Aquajet with a portable water source – assemble the filter to the short portable
hose pipe supplied with the product and then connector the other hose connector to the
Aquajet connector and place into the water source
Connect the hose
Attach the hose to the Aquajet connector, make sure it is locked in to position when you hear
the sound "click" .
In keeping with current regulations a pressure washer must never be operated from the
drinking water mains supply without a controllable backflow preventer. A suitable backflow
preventer in conformity with EN 12729 type BA must be used.
Water that has passed through a backflow preventer is classified as undrinkable.
NOTE: A backflow preventer is available from specialist retailers.
NOTE: Water pressure out from the tap should not higher than 0.6Mpa.
23