Electrolux EFC1060 Manual page 12

12 www.electrolux.com
USE
The hood can be switched on pushing directly onto the requested speed without firstly
having to select 0/1 button.
Basic function
Button
Dual Function
Press briefly to turn the lighting system on and off.
Press and hold the button for 2 seconds to activate the light-
ing system in "courtesy light" mode. The lights are lit at a
L
reduced power of approximately 5W. This function can be
disabled by pressing the button once again for 2 seconds
or by pressing it briefly to switch to normal lighting mode.
Turns the motor off from whatever speed it is set to.
T1
Press and hold the button for 3 seconds with all the loads
turned off (Motor and Lights), to turn the Activated Charcoal
Filter alarm on/off.
T2 Turns the motor on at speed one.
When pressed briefly, turns the motor on at speed two.
Press and hold the button for approximately 2" to turn the
Delay function on and off, that is to say to turn the appliance
T3
off after a 20 minute delay. Suitable to complete elimination
of residual odours. Can be activated from the OFF position
and from speeds 1, 2, 3. Cannot be activated with Intensive
speed On.
T4 Turns the motor on at speed three.
Turns the motor On and Off at Intensive speed for a timed
period of 5 minutes. At the end of the 5 minutes the ap-
pliance will automatically return to the speed that was set
T5
before. If the appliance was turned off at the time of activa-
tion, at the end of the 5 minutes the system will return to
speed one.
Press and hold for 4 seconds to reset the filter alarm indica-
F tor, shown by flashing of button T1. This procedure can only
be carried out with the motor off.
L T1 T2 T3 T4 T5 F
Indicator lights
Button off Lights off
Button lit Lights on
Button lit Courtesy light on
Button lit Motor active
Motor inactive
Button flashes twice F – Alarm On.
Button flashes once F – Alarm Off.
Button on
Button on Speed two on
B u t t o n s
f l a s h i n g
Delay functionActive
(T1+T2 or T3
or T4)
Button on
Button on
Signals the Metal Grease Filter satu-
ration alarm, indicating that it is nec-
Button on essary to wash the filters. The alarm
is triggered after the Hood has been
in operation for 100 working hours.
When this is activated, it signals the
Activated Charcoal Filter satura-
tion alarm, indicating that the filter
must be changed; the Metal Grease
Button
Filters must also be washed. The
flashing
Activated Charcoal Filter saturation
alarm comes into operation after
the Hood has been working for 200
hours.