Table of Contents
Advertisement
PE8720-en.book Page 31 Friday, May 13, 2005 5:19 PM
To clean the filter:
1.
Shut down the projector if turned on and wait
until the fans stop running.
3.
Remove the filter cover by gently lifting the
loosened cover vertically upwards and then away
from the projector body.
5.
Use a small vacuum cleaner (designed for
computers and other office equipment) or use a
soft brush (such as a clean artist's paintbrush) to
vacuum or sweep the dust away.
If the dirt is difficult to remove or the filter is
•
broken, you should replace it.
7.
Reapply power and turn the projector on.
If the filter grill is not correctly seated in place,
•
you will be reminded by a message displayed
on the screen every three minutes until
MENU/EXIT on the projector or EXIT on the
remote control is pressed.
Please check if the filter is well attached.
The projector will automatically shut down
•
within minutes if there has been no further
action taken. Re-install the filter and cover
securely, then turn on the power again.
2.
Release the bottom edge of the filter cover (right
side of projector) by gently pulling the tabs on the
lower ends of the panel (as illustrated).
4.
Remove the dust filter grill by pulling the tab
outwards and away from the projector.
6.
Re-install the filter grill and cover securely.
8.
Go to Setup > Reset Dust Filter Timer to reset the
filter timer.
See page 28
for details.
Additional information
31
Advertisement
Table of Contents
