Mercedes-Benz E-Class Owner's Manual page 375

X
Make sure the vehicle is stationary and the
ignition is switched off.
X
Turn the key to position 2(
the ignition lock.
Use the key instead of the Start/Stop but-
ton on vehicles with KEYLESS-GO.
X
Depress and hold the brake pedal.
X
Shift the automatic transmission to posi-
tion N.
X
Release the brake pedal.
X
Release the parking brake.
X
Switch off the ignition and leave the key in
the ignition lock.
You can wash the vehicle in an automatic car
wash from the very start.
Wash off excess dirt before cleaning the vehi-
cle in an automatic car wash.
After using an automatic car wash, wipe off
wax from the windscreen and the wiper
blades. This will prevent smears and reduce
wiping noises caused by residue on the wind-
screen.
Washing by hand
In some countries, washing by hand is only
allowed at specially equipped washing bays.
Observe the legal requirements for each indi-
vidual country.
X
Do not use hot water and do not wash the
vehicle in direct sunlight.
X
Use a soft sponge to clean.
X
Use a mild cleaning agent, such as a car
shampoo approved by Mercedes-Benz.
X
Thoroughly hose down the vehicle with a
gentle jet of water.
X
Do not point the water jet directly towards
the air inlet.
X
Use plenty of water and rinse out the
sponge frequently.
X
Rinse the vehicle with clean water and dry
thoroughly with a chamois.
X
Do not let the cleaning agent dry on the
paintwork.
When using the vehicle in winter, remove all
traces of road salt deposits carefully and as
soon as possible.
Y page 177) in
High-pressure cleaning equipment
G
The water jet of circular-jet nozzles (dirt grind-
ers) can cause damage not visible from the
outside to tyres or chassis components. Com-
ponents damaged in this way can unexpect-
edly fail. There is a risk of an accident.
Do not use high-pressure cleaners with circu-
lar-jet nozzles to clean the vehicle. Have dam-
aged tyres or chassis components replaced
immediately.
!
!
WARNING
Always maintain a distance of at least
30 cm between the vehicle and the high-
pressure cleaner nozzle. Information about
the correct distance is available from the
equipment manufacturer.
Move the high-pressure cleaner nozzle
around when cleaning your vehicle.
Do not aim directly at any of the following:
tyres
R
door gaps, roof gaps, joints etc.
R
electrical components
R
battery
R
connectors
R
lights
R
seals
R
trim elements
R
ventilation slots
R
Damaged seals or electrical components
can lead to leaks or failures.
If the key is within the rear detection
range of KEYLESS-GO, the following situa-
tions, for example, could lead to the unin-
tentional opening of the boot/tailgate:
using a car wash
R
using a high-pressure cleaner
R
Make sure that the key is at least 2 m away
from the vehicle.
Care
373
Z