Table of Contents
Advertisement
1.0 Transport & Handling
1.1 Transport
The Silverstar belt grinding machine is packed in protective wrapping and delivered
on a pallet with the following measures: 120 x 80 x 120 cm
1.2 Handling
The machine can easily be transported on the pallet on which it is delivered.
1.3 Placing
Mounting of the belt grinder must take place on a firm and level ground. The machine
must be fastened to the ground by means of the four fittings which are used to
fasten the belt grinder to the pallet.
The machine is provided with no-volt release protection switch and connected for
the wanted voltage (V). The electrical connection must be performed by an
authorized electrician, and it is important to control that the motor (and ventilator)
has the correct direction or rotation (please see the arrow on the motor).
Eye shields, suction hose and perhaps dust bag must be mounted before use. The
clamps for mounting the suction hose are placed in the dust bag. The eye shields (A)
must be mounted into the eye shield fitting (see fig.: 1.1).
Fig.: 1.1
The tool rest (B) must be mounted at minimum 2 mm from the belt, and the handle (C)
must be fastened. Turn the contact wheel by your hand and adjust the belt by means
of the handle (D) until it runs just on the contact wheel (E). It must be controlled that
the spark box (F) is properly fastened. The wanted working height is adjusted by
bolt/locknut (G).
5
Advertisement
Table of Contents
