Sony UP-D72XRS Read Before Use page 16

6
Remove the paper tray again. Remove the head
cleaning sheet and place the roller cleaning sheet in
the paper tray, and re-insert the paper tray.
Note
Place the roller cleaning sheet in the paper tray,
following the instruction described on the roller
cleaning sheet.
Roller cleaning sheet
(Place this side up when loading.)
Hole
Paper fed direction
7
Repeat steps 3, 4 and 5 to clean the roller.
8
Remove the roller cleaning sheet. Re-load the paper
removed in step 1 and re-insert the paper tray.
To clean the thermal head
If the printout quality deteriorates, for example, when
white strips still appear on the printouts, even after you
have cleaned the thermal head and roller using the
cleaning sheets, you should clean the thermal head using
the thermal head cleaning kit (supplied).
For detailed information on how to use the thermal head
cleaning kit, refer to the operating instructions supplied
with the thermal head cleaning kit.
1
Press the G, g, and EXEC buttons simultaneously.
The thermal head is released.
2
Press the POWER switch to turn off the printer.
3
Remove the screw from the maintenance door
located on the left side panel and open the door.
6
Cleaning
4
5
6
Paper tray
7
Cleaning the filter
Ventilation holes are provided on the right side and the
rear of the printer to prevent the unit from overheating.
When the message "CLEAN FAN FILTER" appears on
the printer window display, the filter covering the
ventilation holes on the rear of the unit has become dirty.
To clean the filter, proceed as follows.
Insert the cleaning tip holder until it stops, then pull
it toward you until the open window on the holder
fully appears.
Insert and pull out the holder about three times.
Remove the cleaning tip holder and close the
maintenance door.
Put the screw removed in step 3 back on the
maintenance door.
Note
Be sure to close the maintenance door and fasten it
with the screw. If the maintenance door is not
locked completely, the maintenance door may
open, and the printer stops the job while printing.
Press the POWER switch to turn on the printer
again.
Open window