Transport, Storage And Packaging - Baxi DN 25 Installation And Operating Instructions For The Specialised Installer

WARNING
Small components
Risk of ingestion Store and install the
components of the solar station out of reach
of children.
Allergies
Health hazard Do not touch the solar
station and avoid any contact if allergies
against the used materials are known.
2.3 Installation, initial operation, maintenance
Installation, initial operation, maintenance and repairs
have to be carried out by authorised and qualified
tradesmen.
(EN 5011 part 1 and VDE 1000 part 10 for work on
electrical appliances).
WARNING
– Risk of injury from excess pressure
– An exceedance of the max. permissible
operating pressure may lead to an
uncontrolled escape of water and to
severe injuries from sudden component
separation.
The max. permissible operating
pressure must be observed when
pressurizing the system.
Wear safety goggles during filling and
leakage test.
– Once filling and flushing have been
completed, all ball valves in the solar
station (return ball valve and the
balancing valve) and in the collector
circuit (e.g. filling and flushing device)
must be opened again
– All ball valves must be in the open
position during operation
– The boiler must be switched off during
maintenance or repair.
– The connection between the storage
cylinder and solar station must be
protected by an additional safety valve
and/or a diaphragm expansion tank
WARNING
The installation must never be flushed with
liquids containing solvents as these can
cause damage to plastic parts (e.g. pump
impellers and seals)
3 Transport, storage and
packaging
3.1 Transport inspection
Upon receipt check delivery for any damages caused
during transit and for completeness.
Any damage must be reported immediately upon
receipt.
3.2 Storage
The solar station must only be stored under the
following conditions:
– Do not store in open air, keep dry and free from
dust.
– Do not expose to aggressive fluids or heat
sources.
– Protect from direct sunlight and mechanical
agitation.
– Storage temperature: –20 °C up to +60 °C,
max. relative humidity of air: 95 %
3.3 Packaging
Packaging material
environmentally friendly.
is to be disposed of
3