Set-Up Location Requirements; Electrical Connection; Inserting/Changing The Remote; Control Batteries - Silvercrest SSTB 10 B2 Operating Instructions And Safety Instructions

Set-up location requirements

For safe and trouble-free operation of the device , the set-up location must fulfil
the following requirements:
■ Place the device on a firm, flat and level surface .
■ Do not operate the device in a hot, wet or extremely damp environment .
■ Keep a minimum distance of 30 cm to heat-emitting devices such as heaters,
ovens, etc .
■ Only operate the device in locations with adequate ventilation .

electrical connection

■ Before you connect the device, compare the connection data (voltage and
frequency) on the mains adapter type plate with that of the intended power
source . These data must agree so that no damage is sustained by the device .
■ Make sure that the mains adapter's connection cable is not damaged and is
not laying over hot surfaces and/or sharp edges .
■ Connect the plug of the connecting cable into the connector for the power
supply on the rear of the unit and plug the mains adapter into a power
outlet . Ensure that the power cable is not stretched tightly or kinked .
■ Place the connecting cable such that no one can stumble over it .
■ Do not place the device, furniture or any other objects on the cable . Do not
kink the cable or knot it and do not connect it to other cables . Never wrap
the cable tightly around other objects otherwise the conductors inside the
cable could break and cause a malfunction .
Inserting/changing the remote control batteries
To insert/change the batteries, proceed as follows:
♦ Pull the cover off the battery compartment of the remote control .
♦ Remove any depleted batteries and insert two new type AAA/micro batteries
into the battery compartment . Be sure to insert the batteries with the correct
polarity .
♦ Slide the cover back onto the battery compartment until it clicks into place .
■ 8 │ GB │ IE │ NI SSTB 10 B2