Before You Brew - Keurig K-2500 Use & Care Manual

K-2500™ BREWER
Whether your brewer is plumbed or has the optional K-2500™ Water Reservoir Kit installed, you will follow the same steps to get brewing. However, you
may see different messages displayed on the touch screen, depending on which water source is installed.
Plumbed brewer:
1
Power On
Locate the power switch on the
back of the brewer and turn the
brewer ON.

BEFORE YOU BREW

2
Confirm Water Supply
If the water supply is already hooked
up and water is turned on, the
brewer's touch screen will display
"Filling hot water tank..." and will
automatically begin to fill the internal
hot water tank.
If the water is not hooked up or
turned on, the brewer's touch screen
will display "Please connect the
brewer to a water source" as shown
above. Make sure the brewer is
plumbed and the water supply is on
in order to proceed.
Brewer with reservoir:
1
Power On
Locate the power switch on the
back of the brewer and turn the
brewer ON.
Continued
2
Add water
FRANÇAIS
ESPAÑOL
Confirm Water Supply
If the water reservoir has a sufficient
amount of water, the brewer's touch
screen will display "Filling hot water
tank..." and will automatically begin
to fill the internal hot water tank.
If there is not enough water, the
message displayed will be "Add
water" as shown above. Make sure
the reservoir is filled to the MAX line
in order to proceed.
9