Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Keurig K-SELECT
Summary of Contents for Keurig K-SELECT
- Page 1 K-SELECT ™ Use & Care Guide Get the most from your new Keurig brewer ®...
- Page 2 Add Water Auto Off Strong Add Water outlet. If you have a Keurig® Water Filter, Place a large mug (12oz. install it now. Refer to your Water minimum) on the drip tray plate. Filter Starter Kit for instructions. Rinse reservoir with fresh water and fill to the MAX fill line.
-
Page 3: Caring For Your Brewer
Do not insert a K-Cup® pod. K-Cup® pod holder by pulling on it until TIP: Refer to support.Keurig.com for video instructions on cleaning the entrance/exit needles. it pops off. To replace it, just snap it back onto the K-Cup® pod holder. -
Page 4: Descaling Your Brewer
Water Filter, remove and set aside. NOTE: The cleaning action of Keurig® Descaling Solution may result in a “foam” dispensed from the brewer. This is natural, as the solution is reacting with the scale inside. For a brewer that is heavily scaled, the brewer may not fill properly after the descaler is added. -
Page 5: Warranty
God. that you register your brewer on Keurig.com/new so that your purchase information will be stored in our system. Keurig will, at its OTHER LIMITATIONS option, repair or replace a defective brewer without charge upon its receipt of proof of the date of purchase. - Page 6 J. K-Cup® Pod Assembly Housing K. Drip Tray Plate L. Drip Tray M. Drip Tray Base For replacement parts, please visit www.Keurig.com Fully experience the benefits that come with your new Keurig® brewer at KEURIG.COM/NEW ✓ REGISTER DISCOVER your new Keurig® brewer...
Need help?
Do you have a question about the K-SELECT and is the answer not in the manual?
Questions and answers
How to clean the filter
To clean the filter for a Keurig SELECT:
1. Remove the filter from the water reservoir by pressing the two buttons on the filter holder and pulling it out.
2. Soak the new filter in a cup or bowl of cold water for 5 to 10 minutes until it sinks.
3. Rinse the soaked filter under tap water for about 60 seconds.
4. Rinse the lower filter holder, including the thin mesh layer and sides, under tap water.
5. Insert the rinsed filter into the filter holder with the rounded top facing up, and replace it in the reservoir.
This answer is automatically generated